Analysis of the tensile strength of 3D printed elements

Authors

  • Donatas Medišauskas Armament and equipment repair depot of the Air Force of the Lithuanian Armed Forces
  • Sergėjus Rimovskis Šiaulių valstybinė kolegija / Higher Education Institution, Lithuania; Associate Professor at the Department of Transport Engineering, Doctor of Technological Sciences
  • Artūras Sabaliauskas Šiaulių valstybinė kolegija / Higher Education Institution, Lithuania; Head of the Department of Transport Engineering, Associate Professor, Doctor of Technological Sciences

DOI:

https://doi.org/10.56131/tmt.2024.3.1.252

Keywords:

3D printing, infill, tension

Abstract

The paper presents investigations of the mechanical properties of PLA plastic samples produced by a 3D printer under tension. The dependence of the maximum load on the selected 3D printing parameters (infill patterns and infill percentage) is compared. Octet, Zig Zag, Triangles and Grid infill pattern and infill percentage 50% and 90% are used.

Downloads

Download data is not yet available.

Published

2024-05-31

How to Cite

Medišauskas , D., Rimovskis, S., & Sabaliauskas, A. (2024). Analysis of the tensile strength of 3D printed elements. Applied Scientific Research, 3(1), 126–131. https://doi.org/10.56131/tmt.2024.3.1.252