Analysis of the tensile strength of 3D printed elements
DOI:
https://doi.org/10.56131/tmt.2024.3.1.252Schlagworte:
3D printing, infill, tensionAbstract
The paper presents investigations of the mechanical properties of PLA plastic samples produced by a 3D printer under tension. The dependence of the maximum load on the selected 3D printing parameters (infill patterns and infill percentage) is compared. Octet, Zig Zag, Triangles and Grid infill pattern and infill percentage 50% and 90% are used.
Downloads
Keine Nutzungsdaten vorhanden.
Downloads
Veröffentlicht
2024-05-31
Zitationsvorschlag
Medišauskas , D., Rimovskis, S., & Sabaliauskas, A. (2024). Analysis of the tensile strength of 3D printed elements. Angewandte Wissenschaftliche Forschung, 3(1), 126–131. https://doi.org/10.56131/tmt.2024.3.1.252
Ausgabe
Rubrik
Artikel
Lizenz
Copyright (c) 2024 Donatas Medišauskas , Sergėjus Rimovskis, Artūras Sabaliauskas

Dieses Werk steht unter der Lizenz Creative Commons Namensnennung - Nicht-kommerziell - Weitergabe unter gleichen Bedingungen 4.0 International.